PUTZMEISTER

Putzmeister PUMI 31-4.79 S

A combined truck mixer, piston pump and four-section placing boom for small and medium concrete pours.

Equipment inquiry

Discuss the required working method, configuration, delivery location, and project timeline with Vernep.

Request equipment
At a glance

Key specifications

Mixer nominal capacity
9 m³
PUMI 31-4.79 S configuration
Vertical reach
30.1 m
Four-section placing boom
Net horizontal reach
22.9 m
Gross horizontal reach is 25.6 m
Maximum downward reach
18 m
Published boom geometry
Standard pump mode
70 m³/h at 75 bar
Maximum theoretical piston-side values
Optional output mode
92 m³/h at 51 bar
Maximum theoretical rod-side values
Equipment profile

Built around the project configuration

The Putzmeister PUMI 31-4.79 S combines a 9 m³ concrete mixer, piston pump and four-section placing boom on one truck. This arrangement lets one machine transport, pump and position concrete for small and medium pours where mobilising separate mixer and boom-pump vehicles would take more space and coordination.

The TMM 31-4 boom reaches 30.1 m vertically and 22.9 m horizontally on a net basis. Its standard piston-side pump mode provides maximum theoretical performance of 70 m³/h at 75 bar, while an optional rod-side arrangement increases output to 92 m³/h at a lower 51-bar pressure.
Technical data

Detailed specifications

Performance data grouped for quick review and comparison.

Mixer and boom

Mixer nominal capacity 9 m³
Published filling ratio 60 percent
Drum speed 1–15 rpm
Water tank 700 L
Boom sections 4
Folding system Z-fold
Vertical reach 30.1 m
Gross/net horizontal reach 25.6 / 22.9 m
Maximum downward reach 18 m
Unfolding height 7.4 m
End hose 3 m
Delivery line DN 100 / 4.5 inches

TMP 1007 S pump

Standard piston-side output/pressure 70 m³/h / 75 bar maximum theoretical
Optional rod-side output/pressure 92 m³/h / 51 bar maximum theoretical
Standard/optional stroke rate 28 / 37 per minute
Delivery cylinders 230 × 1,000 mm
Pump system S-transfer-tube piston pump
Operating qualification Maximum output and maximum pressure are not simultaneous

Support and controls

Support system FLEX fully variable support system
Support monitoring iSC
Control system Ergonic 3
Remote control Radio remote control with display
Diagnostic display EGD
Mixer control EMC
Output control EOC 2.0
Pump control EPS
Chassis qualification Dimensions, axle loads and road mass are configuration dependent
Equipment inquiry

Match the machine to your project.

Send Vernep the required drilling method, pile diameter, target depth, ground conditions, available working height, delivery location, and project timing. We will use those details to review a suitable configuration or available unit.

Request equipment support